DKS 9100 Manuel du propriétaire télécharger pdf (Page 34)

2.8.2 AUXILIARY TERMINAL

The auxiliary terminal is located on the 4602 circuit board just to the right of main terminals 8 and 9.

Auxiliary terminals are numbered 1 through 5 with the first terminal at the top.

1. OPEN PHOTO-BEAM

This input is only active when the gate is in the opening cycle. An open photo-beam input

during the opening cycle will cause the gate to stop. The gate will remain stopped until

the photo-beam input is cleared, at which time the gate will resume the open cycle.

2. CLOSE PHOTO-BEAM

This input is only active when the gate is in the closing cycle. A close photo-beam input

during the closing cycle will cause the gate to stop. The gate will remain stopped until the

photo-beam input is cleared, at which time the gate will resume the close cycle.

3. OPEN EDGE

This input is only active when the gate is in the opening cycle. An open edge input during

the opening cycle will cause the gate to stop and then reverse.

If the gate reaches the full closed position, the gate will remain closed, ignore any

maintained inputs and enter a soft shutdown condition. NOTE: If the gate was initially

activated by a time clock with a contact closure across the gate operator open input, this

input will be ignored until another input (open loop, reverse loop. etc.) is received by the

gate operator.

If a close edge sensor is activated prior to the gate reaching the full closed position, the

gate will stop and enter a soft shutdown condition.

4. CLOSE EDGE

This input is only active when the gate is in the closing cycle. A close edge input during

the closing cycle will cause the gate to stop and then reverse.

If the gate reaches the full open position, the timer will automatically close the gate (if it is

turned on). Once the gate starts to close again, if the close edge input is activated a

second time prior to the gate reaching the full closed position, the operator will stop and

reverse and will enter a soft shutdown condition.

If an open edge sensor is activated prior to the gate reaching the full open position, the

gate will stop and enter a soft shutdown condition.

5. COMMON

Common terminal for the secondary entrapment protection device inputs.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 52 53

Pas de commentaire

DKS 9100 Manuel du propriétaire Page 34