DKS 9100 Manuel du propriétaire télécharger pdf (Page 18)

1.5.2 FRONT – POST MOUNT

1. Secure the chain brackets to each end of the gate so

that the brackets are level with the bottom chain

idlers in the operator housing. Brackets should be

attached to the inside of the frame so that the chain

bolts, when attached, do not protrude beyond the

frame of the gate.

2. Route the chain through the gate operator: under the

chain guide idlers and over the drive sprocket (Figure

15).

3. Slide each end of the chain through a chain stop

(optional). Chain stops are not required if the gate

has physical stops.

4. Attach the chain to the chain bolts using the master

links supplied, and then attach the chain bolts to the

chain brackets using the hardware supplied (figure

13). Make any adjustments to the chain length at this

time.

5. Adjust the chain bolts to tighten the chain. The chain

should sag no more than one (1) inch per 10 feet of

travel. Do not over tighten the chain.

IMPORTANT!!

Be sure that the chain is parallel to the gate

(figure 14). Installing the chain in any other

manner will cause excessive noise, chain idler

wear and chain stretching

6. Manually open the gate to the full open position and

secure the chain stop (if installed) to the chain so that

it is in contact with the operator housing.

7. Manually close the gate to the full closed position and

secure the chain stop (if installed) to the chain so that

it is in contact with the operator housing.

Figure 13

Figure 14

Figure 15

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

Pas de commentaire

DKS 9100 Manuel du propriétaire Page 18