DKS 9100 Manuel du propriétaire télécharger pdf (Page 35)

SECTION 3 - ADJUSTMENTS

The switch settings and adjustments in this chapter should be made after your installation and wiring

to the operator(s) is complete. Whenever any of the programming switches on the circuit board are

changed, power must be shut-off, and then turned back on for the new setting to take effect.

3.1 Circuit Board Adjustments

• Set the DIP-switches on the circuit board to the desired setting. See switch-setting charts in

section 3.2.

• Auto close timer (when turned on) can be set from 1 second (full counter clockwise) to

approximately 23 seconds (full clockwise).

• Dry contact relay (terminals 15-16) can be set for Normally Open (NO) or Normally Closed

(NC) operation by placing the relay shorting bar on the NO or NC pins respectively.

• Power LED indicates that low voltage power is applied to the circuit board. Input LEDs should

be OFF and will only illuminate when the input is activated. The pulse LEDs will blink as the

operator is running. They can be either ON or OFF when the operator is stopped.

1 2 3 4 5 6 7 8

Timer

Reverse

Sensitivity

Power

Counter

LEDs

Relay Contact

Exit

Loop

Reverse

Loop

Figure 29

9100-065-D-5-07 Page 35

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 52 53

Pas de commentaire

DKS 9100 Manuel du propriétaire Page 35