DKS 9100 Manuel du propriétaire télécharger pdf (Page 23)

1.5.3 Rear – Pad or Post Mount

1. Install an endless idler assembly (p/n

2600-818) at the gate opening between

the gate and fence (figure 16, 18). Note

that the chain is routed between the

fence and the gate in this type of

installation. IMPORTANT!! Be sure that

the idler assembly is securely

attached to the gatepost, pilaster, etc.

2. Secure the chain brackets to the gate as

shown in figure 16. The chain brackets

should be attached to the gate frame so

that they are approximately one (1) inch

apart.

Fi

g

ure 16

3. Route the chain through the gate

operator: over the chain guide idlers and

around the drive sprocket (Figure 18),

and around the idler assembly.

4. Attach the chain to the chain bolts using

the master links supplied, and then

attach the chain bolts to the chain

brackets using the hardware supplied

(figure 16). Make any adjustments to the

chain length at this time.

5. Adjust the chain bolts to tighten the

chain. The chain should sag no more

than one (1) inch per 10 feet of travel. Do

not over tighten the chain.

IMPORTANT!! Be sure that the chain

is parallel to the gate (figure 17).

Installing the chain in any other

manner will cause excessive noise,

chain idler wear and chain stretching.

Figure 17

6. Manually operate the gate to be sure that

the chain is not binding and that the gate

operates easily.

Figure 18

9100-065-D-5-07 Page 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 52 53

Commentaires sur ces manuels

Pas de commentaire